I also downloaded the manual directly from the Harrison site. (11-11-2021, 07:33 PM)bayswater Wrote: New to 32C V7.1 from V5, I’m going through the manual that came with the app download. Either I have the wrong manual or the wrong app version, or both. How do you do look recording with punch in and out, using the loop indicators to set pre and post roll? The manual seems to indicate you can do this, and use the Loop command to control the transport, but the Loop command turns Punch off.Īt this point, I stopped reading and trying out V7. P 135 Following these instructions in the Loop Record video, (set a loop range, set a punch range, turn the punch indicators on, record arm tracks, press record, then press L to start the Loop) When I do this, pressing L turns the punch indicators off, so recoding happens for the entire loop range, not just between the Punch points. How do you reset the vertical meters in the lower part of the window? “ This only work for the meters on the tracks at the top of the page. Double clicking in this area will reset that track’s peak indicator. P 116 “The meter displays the signal level on the track, and has a peak indicator. On markers: are there no default Start and End markers at the session start? If you record something these appear, but they do not appear to be dependent on having any regions, because you can delete the regions and the markers remain. Is this the way it is supposed to be? Odd if what you are looking for as you scroll is in the regions, rather than the header.Ĥ. The tracks themselves stay put until there is some sort of mouse movement over this section. P 95 Scrolling vertically in the Edit page with mouse wheel only scrolls the track headers. And even in the Record window this option does not appear in the “main transport bar”. In fact Display Monitor Options appear on in the Record window, and not in the other windows, and preferences do not address it as far as I can see. There is a “Display Monitor Section Info” box but it does not show the same things. There is no “Display Monitor Options” there in Preferences. On p 88, it reads “To enable the “monitoring options” section of the toolbar, visit Preferences->Appearance->Toolbar and enable “Display Monitor Options” The other two controls, Units and Speed do appear, but I can’t find a Mode option here.Ģ. Wheel: control remains at its last location. Sprung: control returns to center position when mouse is released. On p 87, right clicking the Jog/Shuttle control is supposed to bring up options, one of which is the Mode, which has two settings: I’m finding things in the manual that don’t correspond to what I see in V7.1, and starting to wonder if there is a newer manual I can’f find.ġ. New to 32C V7.1 from V5, I’m going through the manual that came with the app download.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |